Wood Rot Prevention

Wood Rot Prevention - There are Many Ways to Prevent Rot

The inspiration for this column came to me this morning as I was greeting people at church. My wife and I are the head ushers at the 10:30 AM mass. In between people dashing through the door to avoid the drops of rain falling from the steel-gray clouds, I looked across the street. A project at a multifamily building was finally completed.

The final job was to erect a new sign near the sidewalk. This sign was covered by a simple roof structure that was anchored to the ground with two rough-sawn 8x8s. They were either oak or cedar. I suspect cedar based on the nut-brown color. A week ago, I saw all the lumber on a pallet ready to be installed over the past few days. That’s how I know the posts were solid wood.

Cedar contains natural wood-preservative chemicals, much like redwood. But it’s not immune to wood rot. In this case, the architect called for the wood posts to be buried and surrounded by concrete. This prevents the structure from tipping over in a windstorm. Vandals could also push it over if above-ground posts were connected to the piers using normal deck-post hardware.

The better solution might have been to use 6x6 treated lumber posts rated for burial and ground contact. Using a table saw, a good carpenter could have easily duplicated the look of a solid cedar post by wrapping the treated lumber posts with four mitered pieces of 3/4-inch cedar.

Are you building a new home or a room addition? Will it be built using lumber? If so, it’s vital this wood be protected from water that will leak past brick and stone veneer, vinyl siding, wood or fiber-cement siding, or any other exterior finish. Builders used 30-pound tar paper many decades ago to waterproof their wood-frame houses.

Tar Paper is Time Tested

I had the good fortune to work with tar paper early in my career. I cut my teeth in the rehabilitation and remodeling business. I took apart old houses and could see tar paper that was 80 years old and still doing its job of keeping wood rot at bay.

Many new products have replaced tar paper. Your job is to get one that allows water vapor to pass through it but not liquid water. Just about every water barrier sold has this capability.

Use Treated Wood Plywood Indoors

Think about the interior areas of your house that might suffer the most from water or water leaks. Bathrooms come to mind. Imagine treating the wood floor joists with copper naphthenate. This is a liquid you can paint onto any untreated lumber. Copper is a natural biocide. It’s the primary component in treated lumber you purchase for outdoor use.

You can even purchase treated plywood for floors if you want to prevent tubs and toilets from falling into the room below. Last week, I purchased some for my lovely wife to use as a false floor in some outdoor planters. Some engineered subflooring says its water resistant and maybe waterproof but I prefer to use real treated plywood. That’s what you’ll find in my outdoor shed. I didn’t want to ever worry if the floor would rot out.

Door and Window Flashing

Are new windows or exterior doors in your immediate or near future? If you have wood under these, you need to make sure water never gets to the wood. Flashing kits are available for exterior doors. You can also make your own using thin, moldable copper. Flashing tapes can be used to create waterproofing under windows. There are quite a few very good videos, including one I recorded years ago, showing how to use this tape under doors and windows.

Roof Flashings - Rot Magnets

What about your roof? Do you know that most wood rot on roofs happens near or below roof flashings? Flashings are transitional roofing materials. They connect roofing material to things that are not roofs.

The step flashing overlap one another and are to be laced into the shingles. The idiot roofer here didn't install them at the right angle. Rain, especially wind-driven rain, can blow under the upper left corner of each piece you see. Copyright 2017 Tim Carter

Understand that caulk is not a long-term solution to fix poor flashing jobs. Roofing cement is no better. This black asphalt cement is just a temporary patching material. The sun’s ultraviolet rays work rapidly to destroy exposed asphalt.

Flashing work must be superior to prevent wood rot on your roof. Once again, there are lots of great videos online, some by flashing manufacturers, that show you the correct way to create rot-proof roofs. You need to understand the process so that when you interview roofers, you can see if they know the best way to install the flashings.

Column 1564

SPONSORS /