Tim Carter shares some tips about nailing down a shed floor. It's important to keep the spacing of the nails about 8 inches on center. Carter prefers red chalk because it's more visible. For more DIY Shed building tips and information and to purchase the actual plans for the shed in this video, click the […]
Tim Carter shows of the finished shed floor plywood layout. Each row is staggered 4 feet from the row before. This adds to the overall strength of the floor system. Be sure to provide the spacing between sheets of plywood for expansion and contraction if you're worried about it. In Carter's case, he use treated […]
Tim Carter shows how to layout the first piece of plywood for a DIY shed floor. It's vital that you have the floor joists square and that you chalk a crisp line that's the width of the plywood. The first piece of plywood must be put along the chalk line with the corner of the […]
Leaky Shed Floor Video Tim Carter shows a very critical detail on the DIY shed floor so you don't end up with a leaky shed floor. It's important to cut away part of the floor joists where the overhead garage door will be so driving rain does not leak under the door into the shed. […]
Foam Insulation Floor Joists Part 2 Video Tim Carter demonstrates how to slide closed-cell foam insulation in between floor joists. You want it snug, but not too snug. If you cut it too tight, it will cause the floor joists to get out of alignment. A table saw is an excellent tool to cut […]
Tim Carter demonstrates how to install foam insulation in floor joists for a DIY shed. To prevent the foam from falling out, Carter cut custom support blocks using scrap pieces of treated plywood. He then built a simple jig that slides over the top of the floor joists to use to ensure the blocks are […]
Tim Carter discusses what you need to think about before you install flat 2 x 4 blocking in between floor joists when using plywood that's NOT tongue and groove. For more DIY Shed building tips and information and to purchase the actual plans for the shed in this video, click the following links: SHED PLANNING: […]
Tim Carter stands on top of the completed floor joists showing progress on the job. For more DIY Shed building tips and information and to purchase the actual plans for the shed in this video, click the following links: SHED PLANNING: https://www.askthebuilder.com/how-to-plan-a-shed SHEDS for STORAGE: https://www.askthebuilder.com/storage-sheds GARDEN SHEDS: https://www.askthebuilder.com/garden-sheds SHED RAMPS: https://www.askthebuilder.com/shed-ramps/ ACTUAL SHED PLANS: […]
Tim Carter shows the special nails and screws you use to install joist hangers. NEVER use roofing nails! Roofing nails are not structural fasteners. For more DIY Shed building tips and information and to purchase the actual plans for the shed in this video, click the following links: SHED PLANNING: https://www.askthebuilder.com/how-to-plan-a-shed SHEDS for STORAGE: https://www.askthebuilder.com/storage-sheds […]
Tim Carter shares a few secret tips about installing joist hangers. These tips help you get the top of the joists flush with the top of a beam, allow you to deal with cupped joists and a secret tip about cutting the correct length of the joist. For more DIY Shed building tips and information […]
Subscribe to the FREE Ask the Builder newsletter to receive professional advice for your home. Complete the form below and each week you'll get:
Unsubscribe at any time. We respect your email privacy.